Disaster Recovery in Router s

-
This information is here primarily for my reference at customer sites; for some odd reason, I seem to be recovering IOS images through ROMMON quite a bit lately. These are the minimum fields to get this going through TFTP rather than XModem. Hopefully you find this beneficial as well!
rommon 1 > IP_ADDRESS=192.168.1.100
rommon 2 > IP_SUBNET_MASK=255.255.255.0
rommon 3 > DEFAULT_GATEWAY=192.168.1.1
rommon 4 > TFTP_SERVER=192.168.1.50
rommon 5 > TFTP_FILE=c2600-adventerprisek9-mz.124-5a.bin
rommon 6 > tftpdnld            (this command kicks off the tftp download)

Comments

Post a Comment

Popular posts from this blog

REVERSE TELNET ON AUX PORT

-
  Requirement :   Need   to   configure   reverse telnet   via   AUX   port. Connect one router's aux port to another device's console port, and telnet to the router.Use reverse telnet to connect to the other device's console via your aux port   Setup   :   Here's how to set it up. 1.       Connect your router's aux port to another device's console port using a Cisco flat crossover cable. 2.       Telnet to your router, enable, and set the aux port up as follows:   R1#conf t R1(config)# line aux 0 R1(config-line)# modem InOut R1(config-line)# transport preferred all R1(config-line)# transport input all R1(config-line)# transport output all R1(config-line)# end 3.       Make sure you have an address on your lo0 interface, and the interface is up. R1#conf t R1(config)#int   lo0 R1(config-if)#ip   add   127.0.0.1 255.255.255.0 Execution : 1)       Come back in enable mode, find out the line number of your AUX port with “show   line”. It will look something l
Read more

Disabling Unneeded Services

-
Step 1: Configure the Physical Interface Because this lab uses only one router, you will simulate an active FastEthernet connection by activating the interface and applying the no keepalive command to initiate an “always up” state, regardless of the existence of a device at the remote end. Normally, you would not use the no keepalive command on a routed interface, except in special circumstances. In this lab, you will use it only for simulation purposes. Configure the R1 physical interface using the IP address shown in the topology diagram. Use the no keepalive command in interface configuration mode, and then use the no shutdown command to activate the interface. Because you have disabled keepalives, the interface status displays as link state (Layer 1) and line protocols state (Layer 2) “up,” even if it is not connected to an external device. R1(config)# interface fastethernet0/0 R1(config-if)# ip address 192.168.10.1 255.255.255.0 R1(config-if)# no keepalive R1(config-if)# no s
Read more