Adding ACLS for allowing access from Client-A LAN to Client-B Lan
Popular posts from this blog
REVERSE TELNET ON AUX PORT
Requirement : Need to configure reverse telnet via AUX port. Connect one router's aux port to another device's console port, and telnet to the router.Use reverse telnet to connect to the other device's console via your aux port Setup : Here's how to set it up. 1. Connect your router's aux port to another device's console port using a Cisco flat crossover cable. 2. Telnet to your router, enable, and set the aux port up as follows: R1#conf t R1(config)# line aux 0 R1(config-line)# modem InOut R1(config-line)# transport preferred all R1(config-line)# transport input all R1(config-line)# transport output all R1(config-line)# end 3. Make sure you have an address on your lo0 interface, and the interface is up. R1#conf t R1(config)#int lo0 R1(config-if)#ip add 127.0.0.1 255.255.255.0 Execution : 1) Come back in enable mode, find out the line number of your AUX port with “show line”. It will look something l
Disabling Unneeded Services
Step 1: Configure the Physical Interface Because this lab uses only one router, you will simulate an active FastEthernet connection by activating the interface and applying the no keepalive command to initiate an “always up” state, regardless of the existence of a device at the remote end. Normally, you would not use the no keepalive command on a routed interface, except in special circumstances. In this lab, you will use it only for simulation purposes. Configure the R1 physical interface using the IP address shown in the topology diagram. Use the no keepalive command in interface configuration mode, and then use the no shutdown command to activate the interface. Because you have disabled keepalives, the interface status displays as link state (Layer 1) and line protocols state (Layer 2) “up,” even if it is not connected to an external device. R1(config)# interface fastethernet0/0 R1(config-if)# ip address 192.168.10.1 255.255.255.0 R1(config-if)# no keepalive R1(config-if)# no s
Comments
Post a Comment