network design model

-

Comments

Post a Comment

Popular posts from this blog

ccnp exams

-
Hi friends these are the valid Dumps for ccnp route exams Route-642-902 http://www.examcollection.com/cisco/Cisco.PassGuide.642-902.v2010-10-7.by.DoDo.255q.vce.file.html http://www.examcollection.com/cisco/Cisco.PassGuide.642-902.v2010-11-27.by.gogy.272q.vce.file.html Switch-642-813 http://www.examcollection.com/cisco/Cisco.CertifyMe.642-813.v2011-01-13.by.Petter.500q.vce.file.html http://www.examcollection.com/cisco/Cisco.TestKing.642-813.v2010-09-20.by.fliper.496q.vce.file.html
Read more

REVERSE TELNET ON AUX PORT

-
  Requirement :   Need   to   configure   reverse telnet   via   AUX   port. Connect one router's aux port to another device's console port, and telnet to the router.Use reverse telnet to connect to the other device's console via your aux port   Setup   :   Here's how to set it up. 1.       Connect your router's aux port to another device's console port using a Cisco flat crossover cable. 2.       Telnet to your router, enable, and set the aux port up as follows:   R1#conf t R1(config)# line aux 0 R1(config-line)# modem InOut R1(config-line)# transport preferred all R1(config-line)# transport input all R1(config-line)# transport output all R1(config-line)# end 3.       Make sure you have an address on your lo0 interface, and the interface is up. R1#conf t R1(config)#int   lo0 R1(config-if)#ip   add   127.0.0.1 255.255.255.0 Executio...
Read more